|
Automatic Width Control FE-7
Basic Components
1 – Measuring Bar
2 – Console FE-7
Automatic Width Control
3 – Calibration Cage Control for lines with IBC
or:
4 – Tubair air regulation unit for lines without IBC
or:
5 – Blowair air regulation unit including radio remote control, for lines without IBC, with continuously rotating dies
The system works alternatively with Tubair or Blowair (depending if you have rotating or stationary dies) which inflates or deflates the bubble automatically according to the measured width. The width is measured with the Measuring Bar located after the collapsing frame.
On system with IBC the control is done by sending signals to the Calibration Cage Control.
All you have to do is to set the desired width on the Console FE-7.
|
